Fence Installation Cost in NYC: 2026 Price Guide

How much does a fence cost in New York City? The honest answer: it depends on material, linear footage, access, and the rules your lot has to follow. But after hundreds of NYC installs, we can give you realistic 2026 ranges — not national averages that ignore what it costs to work in the five boroughs. Every price below is a typical installed range; your free estimate gives you a fixed written number for your exact property.

2026 NYC Fence Pricing by Material

These are per-linear-foot installed ranges for standard residential heights (4-foot front, 6-foot rear):

  • Chain link: $20–$35/ft galvanized; $25–$45/ft vinyl-coated or 6-foot heights
  • Pressure-treated pine: $25–$45/ft for 6-foot privacy
  • Cedar: $30–$55/ft for 6-foot privacy
  • Vinyl (PVC): $45–$75/ft for 6-foot privacy
  • Ornamental steel: $60–$110/ft installed
  • Custom wrought iron: $90–$150+/ft depending on design complexity

For detail on each material, see our chain link, wood & cedar, vinyl, and wrought iron service pages.

What Gates Add to the Price

Gates are priced separately because they are the most engineered part of the fence. Walk gates typically add $600–$2,000 depending on material and width. Driveway gates run $3,000–$10,000+ installed, and automation — opener, keypad, safety sensors — adds $1,500–$4,000. A sagging old gate can often be repaired for $300–$1,500; see our gate installation & repair page.

What Moves Your Price Up or Down

Linear footage is the biggest factor, but these matter too. Access: a landlocked Park Slope backyard reached through the house costs more in labor than an open Staten Island lot. Terrain: slopes, rock, and old concrete footings add work. Removals: tearing out an old fence adds $5–$15 per foot. Rules: landmark-district approvals and board submittals add time. Masonry: iron fences set into existing stone or brick cost more than post-in-ground installs.

Typical NYC Job Totals

To make it concrete: a 50-foot brownstone backyard in cedar usually lands $3,000–$7,000. A 150-foot detached-home perimeter in vinyl runs $8,000–$18,000. A 25-foot areaway iron run with a walk gate lands $4,000–$12,000. A 100-foot commercial chain link perimeter at commercial spec runs $3,000–$6,000 plus gates. These are 2026 estimates based on our actual installs — your lot gets a fixed written quote, free.

The Cheapest Fence Isn't the Cheapest

A $2,000 fence that leans in three years costs more than a $5,000 fence that stands for twenty. The failures we get called to fix are almost always the same: posts set shallow or without concrete, untreated wood buried in soil, thin vinyl, ungalvanized steel. Our quotes include the unglamorous stuff — deep concrete footings, proper materials, real hardware — because that is what makes a fence last. Request your free estimate and compare apples to apples.

Frequently Asked Questions

What is the cheapest fence to install in NYC?

Chain link — roughly $20–$35 per foot installed for standard residential heights. It is the lowest-cost option that still lasts 15–20 years when installed properly.

How much does a 100-foot privacy fence cost in NYC?

Roughly $3,500–$5,500 in pressure-treated pine, $4,500–$7,500 in cedar, or $6,000–$9,500 in vinyl — before gates. Access and terrain move these numbers.

Are free estimates really free?

Yes. We measure your property, check the applicable rules, and give you a fixed written quote — no charge, no obligation, no pressure.

Get Your Free Fence Estimate

Measured on site, priced in writing — the number we quote is the number you pay.

Get a Free Quote Call (917) 555-0100